You may also use another version of the UltraStudio, such as the following, but not all versions of the UltraStudio support the same capabilities. Check your camera settings and/or manual to see what your camera is capable of.ĭon't forget to plug in the UltraStudio to power it up and then connect it to your Mac via Thunderbolt. Some cameras are limited in what formats they can send out via HDMI or SDI. Important: Your cameras must be outputting a video signal that matches the ATEM video standard set in the previous step! For example, if you set your ATEM to 1080p29.97, your cameras must be putting out 1080p29.97. Plug your cameras into the ATEM inputs and connect a monitor to the Multi-View output. When you click the icon, the ATEM Software Control app opens.Ĭlick on the gear icon in the lower left corner and set your desired video standard. Once you have your computer communicating across the network with your ATEM, the ATEM Setup app will show a new icon that launches the ATEM Software Control app. ![]() ![]() Notice that the two IP addresses are not identical, but in the same range. In this case, I changed my network settings to be in the same range as the default ATEM settings: You want the ATEM's IP address to be in the same range as your computer's network settings. Here you can see the default network settings: With a USB connection, you should see this screen:Ĭlick on the settings icon to go to the IP settings: If you have a recent Macbook Pro, you may need a Thunderbolt to Ethernet Adapter (pictured below) in order to connect to the ATEM. The ethernet connection is for controlling the ATEM and the USB connection is for setting the IP address on the ATEM.įor those that are new to the ATEM, I'll note here that the ATEM does not come with a power cord, nor does it have a power button! You can connect the ATEM directly to your Mac via ethernet, or you can have them both connected to an existing network. Once installed, in your Applications folder you'll find the Blackmagic ATEM Switchers folder.īefore you launch the ATEM Setup App, power up your ATEM and connect it to your Mac via both ethernet and USB. and download the latest version of the ATEM software for OSX. ![]()
0 Comments
Leave a Reply. |